Dell 5100MP Owner's Manual

Also see for 5100MP - SXGA+ DLP Projector: Specifications User guide MIB Definitions Guide Setup guide Owner's manual

Contents

w w w . d e l l . c o m | s u p p o r t . d e l l . c o m34 Using Your ProjectorPIP I MAGE —Select On to enter Options toselect following settings. Select Off todisable the picture-in-picture displayfunction.PIP SOURCE —Use PIP Source to step throughthe display source one by one for theforeground display. The possible PIP source isavailable in the OSD selection depending onthe current primary input source. The possiblecombination of the sources refer to page 56.PIP SIZE —Adjust the image size of the foreground display.PIP X POSITION —Horizontally adjust the image position of the PIP display.PIP Y POSITION —Vertically adjust the image position of the PIP display.PBP I MAGE —Select On to enable the picture-by-picture display. Select Off todisable the picture-by-picture function.Network Settings MenuDHCP —Select On to assign an IP address tothe projector from a DHCP serverautomatically. Select Off to assign an IPaddress manually.IP A DDRESS —Press Enter to set up an IPaddress. Press left or right button to select thenumber position, up or down button to changethe number.SUBNET M ASK —Press Enter to set up an subnetmask number. Press left or right button toselect the number position, up or down buttonto change the number.G ATEWAY —Select to set the default gateway ofthe network connected to the projector. Pressleft or right button to select the numberposition, up or down button to change the number.DNS—Type in the IP address of DNS server on the network connected to theprojector. 12 numeric characters are used.APPLY CHANGE—Press to confirm the settings.RESET NETWORK SETTING—Press to the default setting.