System Information Guide 33Canada—Industry Canada (IC)This device complies with RSS210 of Industry Canada. (1999)FCC standard47 CFR Part 15, Subpart C (Section 15.247)Federal Communications Commission (FCC)This device complies with Part 15 of the FCC Rules. Operation of the device is subject to thefollowing two conditions:• This device may not cause harmful interference.• This device must accept any interference that may cause undesired operation.NOTE—The radiated output power of this Dell Axim X3 device is far below the FCC radiofrequency exposure limits. Nevertheless, the Dell Axim X3 device should be used in such amanner that the potential for human contact during normal operation is minimized. Todetermine the location of the antenna within your computer, check the information posted onthe general Dell support site at support.dell.com.Interference statementThis equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy. If the equipment is not installed and used inaccordance with the instructions, the equipment may cause harmful interference to radiocommunications. There is no guarantee, however, that such interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or televisionreception (which can be determined by turning the equipment off and on), the user isencouraged to try to correct the interference by taking one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the distance between the equipment and the receiver.• Connect the equipment to an outlet on a circuit different from that to which thereceiver is connected.• Consult the dealer or an experienced radio/TV technician for help.NOTE—This Dell Axim X3 device must be installed and used in strict accordance with themanufacturer's instructions as described in the user documentation that comes with theproduct. Any other installation or use will violate FCC Part 15 regulations.NOTE—FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolledenvironment. End users must follow the specific operating instructions for satisfying RFexposure compliance.
