Dell Dimension 5100 Service Manual

Also see for Dimension 5100: Setup guide System information guide Setup User manual Owner's manual

Connect CD/DVD drives to the connector labeled "IDE1" on the system board. Serial ATA hard drives should be connected to the connectors labeled "SATA0" or"SATA2" on the system board.IDE Drive AddressingWhen you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector onthe interface cable is the master or boot device (drive 0), and the device attached to the middle connector on the interface cable is the slave device (drive 1).See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.Connecting and Disconnecting Drive Interface CablesWhen you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the system board.When removing an IDE drive data cable, grasp the colored pull-tab and pull until the connector detaches.Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the otherconnector. Keyed connectors ensure that the pin-1 wire in the cable (indicated by the colored stripe along one edge of the IDE cable—serial ATA cables do notuse a colored stripe) goes to the pin-1 end of the connector. The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened "1"printed directly on the board or card.Power Cable ConnectorTo connect a drive using the power cable, locate the power connector on the power supply.1 CD/DVD drive(s)2 FlexBay for optional floppy drive or optional Media Card Reader3 hard drive(s)NOTICE: When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of the connector. Reversing the cable prevents thedrive from operating and could damage the controller, the drive, or both.1 interface cable2 interface connector