Removing and Installing Parts 115Installing a Media Card ReaderCAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the ProductInformation Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from yourbody before you touch any of your computer’s electronic components. You can do so by touching an unpaintedmetal surface on the computer chassis.1 Follow the procedures in "Before You Begin" on page 77.2 Lay the computer on its side so that the system board is on the bottom of the inside of the computer.3 Remove the computer cover (see "Removing the Computer Cover" on page 78).4 Remove the drive panel (see "Removing the Drive Panel" on page 100).5 Remove the drive panel insert (see "Removing the Drive-Panel Insert" on page 101).6 Remove the Media Card Reader from its packaging.7 Remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the newdrive.8 Gently slide the drive into place until you feel a click or feel the drive securely installed.NOTE: Ensure that the Media Card Reader is installed before connecting the USB cable.1 Media Card Reader 2 screws (4)12
