Dell E60S Installation And Service Manual

Also see for E60S: Installation and service manual

Figure 42. Removing the tape driveNext steps1. Replace the tape drive.2. Follow the procedure listed in After working inside your system.Installing the tape drivePrerequisites1. Ensure that you follow the procedure listed in Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Remove the front bezel.4. If applicable, remove the tape drive blank.NOTE: The procedure to remove the tape drive blank and the tape drive is similar.Steps1. Align and slide the tape drive into the tape drive bay until it clicks into place.2. Using the Phillips #2 screwdriver, secure the tape drive to the drive bay.3. Connect the power and data cable connectors to the connectors on the tape drive.4. Connect the power and data cable connectors to the backplane and the system board.NOTE: Route the cables properly to prevent them from being pinched or crimped.46 Installing and removing system components