Option Description• Capacity: Specifies the total capacity of the hard drive. This field is undefined forremovable media devices such as optical drives.Port G Sets the drive type of the selected device. For the Embedded SATA settings in ATAmode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOSsupport.For AHCI mode, BIOS support is always enabled.Port H Sets the drive type of the selected device. For the Embedded SATA settings in ATAmode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOSsupport.For AHCI mode, BIOS support is always enabled.• Model: Specifies the drive model of the selected device.• Drive Type: Specifies the type of drive attached to the SATA port.• Capacity: Specifies the total capacity of the hard drive. This field is undefined forremovable media devices such as optical drives.Port I Sets the drive type of the selected device. For the Embedded SATA settings in ATAmode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOSsupport.For AHCI mode, BIOS support is always enabled.• Model: Specifies the drive model of the selected device.• Drive Type: Specifies the type of drive attached to the SATA port.• Capacity: Specifies the total capacity of the hard drive. This field is undefined forremovable media devices such as optical drives.Port J Sets the drive type of the selected device. For the Embedded SATA settings in ATAmode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOSsupport.For AHCI mode, BIOS support is always enabled.• Model: Specifies the drive model of the selected device.• Drive Type: Specifies the type of drive attached to the SATA port.• Capacity: Specifies the total capacity of the hard drive. This field is undefined forremovable media devices such as optical drives.Integrated DevicesYou can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,integrated RAID controller, and the USB ports.Viewing Integrated DevicesAbout this taskTo view the Integrated Devices screen, perform the following steps:Steps1 Turn on, or restart your system.2 Press F2 immediately after you see the following message:40 Pre-operating system management applications
