Dell EMC DSS 9620 Installation And Service Manual

Contents

Miscellaneous Settings detailsThe Miscellaneous Settings screen details are explained as follows:Table 35. Miscellaneous SettingsOption DescriptionSystem Time Enables you to set the time on the system.System Date Enables you to set the date on the system.Asset Tag Specifies the asset tag and enables you to modify it for security and tracking purposes.Keyboard NumLock Enables you to set whether the system boots with the NumLock enabled or disabled. Thisoption is set to On by default.NOTE: This option does not apply to 84-key keyboards.F1/F2 Prompt on Error Enables or disables the F1/F2 prompt on error. This option is set to Enabled by default. TheF1/F2 prompt also includes keyboard errors.Load Legacy Video Option ROM Enables you to determine whether the system BIOS loads the legacy video (INT 10H)option ROM from the video controller. Selecting Enabled in the operating system does notsupport UEFI video output standards. This field is available only for UEFI boot mode. Youcannot set the option to Enabled if UEFI Secure Boot mode is enabled.In-System Characterization Enables or disables In-System Characterization. This option is set to Disabled by default.The two other options are Enabled and Enabled - No Reboot.NOTE: The default setting for In-System Characterization is subject to changein future BIOS releases.When enabled, In-System Characterization (ISC) executes during POST upon detectingrelevant changes in system configuration to optimize system power and performance. ISCtakes about 20 seconds to execute, and system reset is needed for ISC results to beapplied. The Enabled - No Reboot option executes ISC and continues without applyingISC results until the next time system reset occurs. The Enabled option executes ISC andforces an immediate system reset so that ISC results can be applied. It takes the systemlonger to be ready due to the forced system reset. When disabled, ISC does not execute.Dell Wyse P25/P45 BIOS Access Enables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled bydefault.Power Cycle Request Enables or disables the Power Cycle Request. This option is set to None by default.iDRAC Settings utilityThe iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable variousiDRAC parameters by using the iDRAC settings utility.NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals.46 Pre-operating system management applications