Dell EMC PowerEdge R740 Installation And Service Manual

Contents

Steps1 Using a Torx #T30 screwdriver, loosen the screws on the heat sink.NOTE: Ensure that you loosen one screw before moving on to the next screw.2 Pushing both retention clips simultaneously, lift the processor and heat sink module (PHM) out of the system.3 Set the PHM aside with the processor side facing up.Figure 44. Removing a processor and heat sink module (2U)Next steps1 Install the PHM.Related linksRemoving the air shroudOpening and closing the PCIe card holder latchInstalling a processor and heat sink moduleRemoving the processor from the processor and heat sinkmodulePrerequisitesWARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink tocool before removing it.1 Follow the safety guidelines listed in Safety instructions.2 Follow the procedure listed in Before working inside your system.3 Remove the processor and heat sink module.Steps1 Place the heat sink with the processor side facing up.2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermalpaste seal.3 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.Dell EMC PowerEdge R740 Installation and Service ManualInstalling and removing system components97