Dell EMC XC Core XC7525 Installation And Service Manual

Figure 110. Removing the intrusion switch moduleNext steps1. Install the intrusion switch module.Installing the intrusion switch modulePrerequisites1. Follow the safety guidelines listed in the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Remove the expansion card riser.NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cableproperly when you replace it to prevent the cable from being pinched or crimpedSteps1. Align the guides on the intrusion switch module with the standoffs on the system.2. Slide the intrusion switch module into the slot in the system until firmly seated.3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.4. Connect the intrusion switch cable to the connector on the rear I/O board.108 Installing and removing system components