Dell EMC XC Core XC7525 Installation And Service Manual

● BIOS default NPS setting is 1.● UEFI0391 message may be displayed during boot if DIMMs are configured in the blank spaces of the table.● If the processor does not support the desired NPS setting for a given number of DIMMs, then use default setting (NPS1)and the UEFI0391 message is displayed.Memory interleaving population rules● NPS4: Two channel interleaving○ This interleaves channel [A and B], [C and D], etc.○ Each channel within the pair requires at least one equal memory modules populated.○ Works with three memory modules per channel pair, non-symmetrical module is stacked on top (odd configurations).○ Any memory channel where one of the two channels is not populated is not interleaved.○ There is no alternate, as all configurations can be mapped into this mode.● NPS2: Four channel interleaving○ This interleaves the four channels on the left or right half of a processor which are channels [A, B, C, D] and [E, F, G, H].○ All four channels require equal memory modules populated.○ Each half or interleave set may have different total memory capacity with respect to each other.● NPS1: Eight channel interleaving○ This interleaves all channels in a processor [A, B, C, D, E, F, G, H].○ All channels in a processor require equal memory modules populated.○ Single processor system creates a single NUMA node for the system.NOTE: An exception is allowed when system has 4-channels populated [C, D, G, H] with equal memory allowing thesystem to enter NPS1 mode even though all the 8 channels are not populated.● NPS0: Sixteen channel interleaving (dual processor)○ This interleaves all 16 channels in a dual processor system.○ All channels in a system require equal memory modules populated.○ Dual processor systems create a single NUMA node for the system.Removing a memory modulePrerequisites1. Follow the safety guidelines listed in the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. If installed, Remove the air shroud.WARNING: The memory modules are hot to touch for some time after the system has been powered off. Allowthe memory modules to cool before handling them. Handle the memory modules by the card edges and avoidtouching the components or metallic contacts on the memory module.Steps1. Locate the appropriate memory module socket.2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory modulesocket.CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of thememory module or metallic contacts.3. Lift the memory module away from the system.Installing and removing system components 67