SATA Settings ScreenMenu Item DescriptionEmbedded SATA Allows the embedded SATA to be set to Off, ATA, AHCI, or RAID mode. By default, EmbeddedSATA is set to AHCI Mode.Port A Auto enables BIOS support for the device attached to SATA port A. By default, Port A is set toAuto.Port B Auto enables BIOS support for the device attached to SATA port B. By default, Port B is set toAuto.Port C Auto enables BIOS support for the device attached to SATA port C. By default, Port C is set toAuto.Port D Auto enables BIOS support for the device attached to SATA port D. By default, Port D is set toAuto.Port E Auto enables BIOS support for the device attached to SATA port E. By default, Port E is set toAuto.NOTE: Ports A, B, C, and D are used for the backplane drives, and port E for the optical drive (CD/DVD).Boot Settings ScreenMenu Item DescriptionBoot Mode Allows you to set the boot mode of the system.CAUTION: Switching the boot mode may prevent the system from booting if the operatingsystem is not installed in the same boot mode.If the operating system supports UEFI, you can set this option to UEFI. Setting this field to BIOSallows compatibility with non-UEFI operating systems. By default, the Boot Mode option is setto BIOS.NOTE: Setting this field to UEFI disables BIOS Boot Settings menu. Setting this field toBIOS disables the UEFI Boot Settings menu.Boot Sequence Retry Allows you to enable or disable the boot sequence retry feature. If this field is enabled and thesystem fails to boot, the system reattempts the boot sequence after 30 seconds. By default, theBoot Sequence Retry option is set to Disabled.BIOS Boot Settings Allows you to enable or disable BIOS Boot options.NOTE: This option is enabled only if the boot mode is BIOS.UEFI Boot Settings Allows you to enable or disable UEFI Boot options.NOTE: This option is enabled only if the boot mode is UEFI.One-Time Boot Allows you to enable or disable a one-time boot from a selected device.26
