Dell External OEMR XL R610 Technical Manual

Also see for PowerEdge R610: Hardware owner's manual Manual Installation Update Installation instructions

Contents

Dell External OEMR XL R610 Technical Manual Manual pdf 29 page image

DellPowerEdge R610 Technical Guide 29 The first two channels per processor populated identically with the third channel unusedo Typically, two channels operate in Advanced ECC (Lockstep) mode with each other byhaving the cache line split across both channels.o This mode provides improved RAS features (SDDC support for x8-based memory).o For memory mirroring, two channels operate as mirrors of each other (writes go toboth channels and reads alternate between the two channels).o For Memory Mirroring or Advanced ECC Mode, the three sockets farthest from theprocessor are unused and memory modules are installed beginning with socket A2 orB2, proceeding in the following order: A2, A3, A5, and A6. One channel per processor populatedo This is a simple Memory Optimized mode.o Mirroring is not supported.7.2.2 DIMM Population RulesThe following DIMM population rules apply: If DIMMs of different speeds are mixed, all channels will operate at the fastest commonfrequency. RDIMMs and UDIMMs cannot be mixed. If memory mirroring is enabled, identical DIMMs must be installed in the same slots acrossboth channels. The third channel of each processor is unavailable for memory mirroring. The R610 supports up to 12 DIMMs. DIMMs must be installed in each channel starting with theDIMM slot farthest from the processor. Population order is identified by the silkscreendesignator and the System Information Label (SIL) located on the chassis cover. DIMM slot population for each memory mode is listed as follows:o Memory Optimized: [1, 2, 3], [4, 5, 6]o Advanced ECC or Mirrored: [2, 3], [5, 6]o Quad Rank or UDIMM: [1, 2, 3], [4, 5, 6]7.3 SpeedThe memory frequency is determined by a variety of inputs: Speed of the DIMMs Speed supported by the processor Configuration of the DIMMsThe memory speed of each channel depends on the memory configuration: For single- or dual-rank memory modules:o One memory module per channel supports up to 1333 MHzo Two memory modules per channel supports up to 1066 MHz For quad-rank memory modules:o One memory module per channel supports up to 1066 Mhzo Two memory modules per channel are limited to 800 MHz, regardless of memorymodule speedIf memory modules with different speeds are installed, they will operate at the speed of the slowestinstalled memory module(s).For quad-rank DIMMs mixed with single- or dual-rank DIMMs, the quad-rank DIMM must be installed inthe slot with the white ejection tabs (the first DIMM slot in each channel). There is no requirementfor the order of single- and dual-rank DIMMs.