Dell Force10 MXL Blade Getting Started Manual

Also see for Force10 MXL 10 GbE: Manual Manual Deployment guide

Dell Force10 MXL Blade Getting Started Manual Manual pdf 33 page image

Next Steps 33Next StepsIf you installed the MXL 10/40GbE Switch in a stack, you can configureadditional settings for switch stacking.For information about how to create different stacking scenarios, refer to theEthernet Stacking white paper on the Dell Support and Dell NetworkingWhite Papers websites at:http://support.dell.com/manualshttp://en.community.dell.com/techcenter/networking/w/wiki/networking-whitepapers.aspxFor information about how to configure stacking, refer to the User’sConfiguration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Moduleon the Dell Support website at http://support.dell.com/manuals.• You can customize the MXL 10/40GbE Switch for use in your data centernetwork by configuring software features as necessary. To performadditional switch configuration, do one of the following:• For remote out-of-band management, enter the OOB managementinterface IP address into a Telnet or SSH client and log in to theswitch using the user ID and password to access the CLI.• For local management, use the attached console connection to log into the CLI.• For remote in-band management from a network managementstation, enter the VLAN IP address of the management port and log into the switch to access the CLI.For information about how to configure software settings, refer to the User’sConfiguration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Moduleon the Dell Support website at http://support.dell.com/manuals.