15. Enter system setup and update the appropriate Primary Drive option (0 or 2).16. Exit system setup, and reboot the computer.17. Partition and logically format your drive before you proceed to the next step.For instructions, see the documentation that came with your operating system.18. Test the hard drive by running the Dell Diagnostics.19. Install your operating system on the hard drive.For instructions, see the documentation that came with your operating system.Floppy DriveRemoving a Floppy Drive1. Follow the procedures in "Before You Begin."2. Remove the CD/DVD drive and carefully set it aside.3. Pull up on the drive release latch and slide the floppy drive towards the back of the computer. Then, lift up to remove the drive from the computer.4. Disconnect the power and floppy-drive cables from the back of the floppy drive.Installing a Floppy Drive1. If you are installing a new drive:a. Use a small flat-edge screw driver on the back side of the panel insert to gently pop off the insert.b. Remove the shoulder screws (4) from the panel insert.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.NOTE: Since the following steps do not require the complete removal of the CD/DVD drive, it is not necessary to disconnect the cables connecting theCD/DVD drive.NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.1 drive release latch2 floppy drive
