Dell INSPIRON Inspiron 5000 Removal And Installation

Also see for INSPIRON Inspiron 5000: Service manual Quick setup guide Owner's manual Get started guide User guide

Contents

LED/Inverter Board2ZIF ConnectorsNOTICE: ZIF connectors are fragile. To avoid breaking the connectors,touch them carefully. Do not apply too much pressure to the movable part ofthe connector when opening or closing it.Some of the interface connectors are zero insertion force (ZIF) connectors. These connectors are not removable; they must bereleased to disconnect a cable from them.To disconnect a cable from a ZIF connector, perform the following steps:Insert a small flat-blade screwdriver, dental pick, or fingernail under the movable part of the connector.1.Pull up gently on the movable part of the connector until the cable is released.Some ZIF connectors may need to be lifted in the center.2.Grasp the cable and pull it out of the connector.3.To reconnect an interface cable to a ZIF connector, perform the following steps:Open the ZIF connector.1.Insert the end of the cable into the connector.2.While holding the cable in place, close the ZIF connector.To ensure a firm connection, make sure the ZIF connector is completely closed.3.Modem RemovalNOTICE: Only a certified service technician should perform repairs on yourcomputer. Damage or inoperability due to servicing not authorized by Dell isnot covered by your warranty.Ensure that all precautionary measures have been followed and that all customer-accessible parts are removed.Remove the modem cover.1.Spread the release tabs on either side of the modem away from the modem.2.Remove the modem.3.Remove the modem cable.4.Removing and Replacing Parts: Dell Inspiron 5000 Seriesfile:///c|/docs/blanco E-doc/removing.htm (8 of 29) [9/1/2000 3:32:00 PM]