Dell Inspiron 14 5420 Service Manual

Also see for Inspiron 14 5420: Setup and specifications

2. Hold the display assembly against the edge of the table, aligning the screw holes on the display hinges with the screw holeson the palm-rest and keyboard assembly.3. Replace the five screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.4. Connect the display cable to the connector on the system board and close the latch.5. Adhere the tape that secures the display-cable connector latch to the system board.Next steps1. Install the base cover.2. Follow the procedure in After working inside your computer.Power-adapter portRemoving the power-adapter portPrerequisites1. Follow the procedure in Before working inside your computer.NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside yourcomputer.2. Remove the base cover.3. Remove the display assembly.4. Remove the heat sink.About this taskThe following image(s) indicate the location of the power-adapter port and provides a visual representation of the removalprocedure.Steps1. Peel the tape that secures the power-adapter port cable to the system board.2. Disconnect the power-adapter port cable from the system board.3. Peel the tape that secures the power-adapter port cable to the palm-rest and keyboard assembly.Removing and installing components 31