Replacing the Display Assembly1. Follow the instructions in Before You Begin.2. Place the display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.3. Connect the display cable to the connector on the system board.4. Route the antenna cables through the routing guides and connect the cables to the Mini-Card (see Replacing the Mini-Card).5. Replace the palm rest (see Replacing the Palm Rest).6. Replace the keyboard (see Replacing the Keyboard).7. Replace the memory module(s) (see Replacing the Memory Module(s)).8. Replace the module cover (see Replacing the Module Cover).9. Follow the instructions from step 3 to step 4 in Replacing the Optical Drive.10. Follow the instructions from step 4 to step 5 in Replacing the Hard Drive.11. Replace the battery (see Replacing the Battery).Display BezelRemoving the Display Bezel1. Follow the instructions in Before You Begin.2. Remove the display assembly (see Removing the Display Assembly).3. Make a note of the Mini-Card antenna cables and the display cable routing on the display hinges.4. Using your fingertips, carefully pry up the inside edge of the display bezel.5. Remove the display bezel.1 display assembly 2 screws (2)3 Mini-Card antennacables4 display cableconnectorCAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.