Back to Contents PageCamera Module (Optional)Dell™ Inspiron™ 1546 Service ManualRemoving the Camera ModuleReplacing the Camera ModuleRemoving the Camera Module1. Follow the procedures in Before You Begin.2. Remove the display assembly (see Removing the Display Assembly).3. Remove the display bezel (see Removing the Display Bezel).4. Remove the display panel (see Removing the Display Panel).5. Disconnect the camera cable from the connector on the camera module.6. Remove the two screws that secure the camera module to the display cover.7. Remove the camera module.Replacing the Camera Module1. Follow the procedures in Before You Begin.2. Replace the two screws that secure the camera module to the display cover.3. Connect the camera cable to the connector on the camera module.4. Replace the display panel (see Replacing the Display Panel).WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.1 screws (2) 2 camera module3 camera cable connector