Back to Contents PageCamera ModuleDell™ Inspiron™ 1764 Service ManualRemoving the Camera ModuleReplacing the Camera ModuleRemoving the Camera Module1. Follow the procedures in Before You Begin.2. Remove the battery (see Removing the Battery).3. Remove the display assembly (see Removing the Display Assembly).4. Remove the display bezel (see Removing the Display Bezel).5. Remove the display panel (see Removing the Display Panel).6. Peel the camera module off the display cover.7. Remove the tape that secures the camera cable to the camera module.8. Disconnect the camera cable from the camera module.Replacing the Camera Module1. Follow the procedures in Before You Begin.2. Connect the camera cable to the connector on the camera module.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on the back of the computer).CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.1 display cover 2 alignment posts (2)3 camera module 4 tape5 camera cable