Back to Contents PageModule CoverDell™ Inspiron™ 1764 Service ManualRemoving the Module CoverReplacing the Module CoverRemoving the Module Cover1. Follow the procedures in Before You Begin.2. Remove the battery (see Removing the Battery).3. Loosen the three captive screws that secure the module cover to the computer base.4. Lift the module cover up at an angle to carefully disengage it from the computer base.Replacing the Module Cover1. Follow the procedures in Before You Begin.2. Align the tabs on the module cover with the slots on the computer base and gently snap the module cover into place.3. Tighten the three captive screws that secure the module cover to the computer base.4. Replace the battery (see Replacing the Battery).Back to Contents PageWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as the back panel) on the computer.CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.1 module cover 2 captive screws (3)3 module cover tabs