Removing and Replacing Parts : Dell Inspiron 8100NOTICE: Disconnect the computer and any attached devices from electrical outlets, andremove any installed batteries.NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodicallytouching an unpainted metal surface on the computer.Removing Media Bay Devices1. Follow the instructions in "Preparing to Work Inside the Computer."2. Close the display, turn the computer upside down on a flat work surface, and remove the mainbattery.3. Remove the device from the media bay.4. Push the module latch toward the right side of the computer. Keep holding the latch open whilepulling the device out of the media bay with the other hand.Memory ModulesNOTICE: Disconnect the computer and attached devices from electrical outlets and remove anyinstalled batteries.NOTICE: To avoid possible damage to the memory module from ESD, ground yourself by usinga wrist grounding strap or by periodically touching an unpainted metal surface on thecomputer.Removing the Memory Module CoverNOTICE: To avoid damaging the system board, you must remove the main battery before youservice the computer.NOTICE: Make sure that the work surface is clean to prevent scratching the computercover.NOTICE: Handle memory modules with care. Do not touch the components on a module. Holda module by its edges.1. Follow the instructions in "Preparing to Work Inside the Computer."2. Remove the screw.3. Disengage the metal tabs at the opposite end of the cover.file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8100/8100_SERVICE_MAN/remove.htm (9 of 52)6/21/2004 1:09:07 AM