Replacing the Palm Rest | 4819 Replacing the Palm RestWARNING: Before working inside your computer, read the safety informationthat shipped with your computer and follow the steps in "Before You Begin" onpage 8. For additional safety best practices information, see the RegulatoryCompliance Homepage at dell.com/regulatory_compliance.Procedure1 Slide the display cable through the slot on the palm rest.2 Align the palm rest with the computer base and gently snapthe palm rest into place.3 Slide the hot-key board cable, power-button board cable, and touchpad cable intothe system-board connectors and press down on the connector latches to securethe cables.4 Route the display cable through the routing guides on the palm rest.5 Connect the display cable to the system-board connector.6 Replace the screws that secure the palm rest to the computer base.7 Close the display and turn the computer over.8 Replace the screws that secure the palm rest to the computer base.Postrequisites1 Replace the keyboard. See "Replacing the Keyboard" on page 24.2 Replace the base cover. See "Replacing the Base Cover" on page 28.3 Replace the battery. See "Replacing the Battery" on page 18.4 Follow the instructions in "After Working Inside Your Computer" on page 10.
