Back to Contents PageWireless Mini-Card(s)Dell™ Inspiron™ N5110 Service ManualRemoving the Mini-Card(s)Replacing the Mini-Card(s)If you ordered a wireless Mini-Card with your computer, the card is already installed.Your computer has one full Mini-Card slot for Wireless Wide Area Network (WWAN) and one half Mini-Card slot for Worldwide Interoperability for MicrowaveAccess (WiMax/WLAN).Removing the Mini-Card(s)1. Follow the instructions in Before You Begin.2. Remove the battery (see Removing the Battery).3. If you are removing the WiMax/WWAN Mini-Card:a. Remove the module cover (see Removing the Module Cover).b. Disconnect the antenna cables from the Mini-Card.c. Remove the screw that secures the Mini-Card to the system board.d. Lift the Mini-Card out of the system-board connector.4. If you are removing the WLAN Mini-Card:a. Follow the instructions from step 3 to step 9 in Removing the Palm-Rest Assembly.b. Disconnect the antenna cables from the Mini-Card.c. Remove the screw that secures the Mini-Card to the system board.d. Lift the Mini-Card out of the system-board connector.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell isnot covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.1 antenna cables (2) 2 Mini-Card3 screw 4 system-board connector