26 Using Your ProjectorLAMPUsing the Lamp menu, you can adjust the display settings of your projectors. ThePicture menu, provides the following options:LAMP H OUR —Displays theoperating hours since the lastlamp timer reset.POWER S AVING—Select Yes toset the Power Saving delayperiod. The delay period isthe time you want theprojector to wait without aninput signal. By default, thedelay period is set to 120minutes. However, you can set this to 5 minutes, 15 minutes, 30 minutes, 45minutes, 60 minutes, or 120 minutes.If an input signal is not detected during the delay period, the projector turns offthe lamp and goes into power saving mode. If an input signal is detected whenprojector is in power saving mode, the projector automatically turns on. If an inputsignal is not detected within two hours, the projector switches from Power Savingmode to Power Off mode. To turn on the projector press the Power button.E CO M ODE —Select On to use the projector at a lower power level (168 Watts).Operating at lower power levels may provide longer lamp life, quieter operation,and dimmer luminance output on the screen. Select Off to operate at normalpower level (212 Watts).LAMP R ESET—After you install a new lamp, select Yes to reset the lamp timer.QUICK S HUTDOWN —Select Yes to turn off the projector with a single press of thePower button. This function allows the projector to cool down within a shortperiod of time by accelerating the fan speed.NOTE: If Quick Shutdown is enabled, expect a slightly higher acoustic noiseduring power off.Downloaded From projector-manual.com DELL Manuals