Dell M5200 Supplementary Manual

Also see for M5200: Owner's manual User guide Quick reference

Maintenance Kit Installation InstructionsDell M5200The following parts are included in your Maintenance KitDell RO238Description Part NumberFuser M1896Transfer Roller N1497Charge Roller J1756Pick Rolls M1546* * * AT T E N T I O N * * *Turn off printer, unplug, and allow it to sit for 30 minutes before performing any of these maintenance procedures.Duty Cycle: 300,000 Pages @ 5% CoverageFuser Removal & Installation:1. Remove any output options.2. If a duplex unit is installed, remove the printer from it by using the handholds.This may require two people.3. Remove the fuser cover. (If you have a label printer, lift up and remove thefuser cleaner.)4. Open the rear access door slightly and pull up at a slight angle to remove.5. Loosen the two screws on the redrive unit; remove the redrive unit bypulling outward by the tabs.6. Loosen the two screws on the fuser asm and pull the fuser from theprinter; to do so, pull the fuser by the metal tab.7. Install the new fuser in reverse fashion.****CAUTION****Do not touch the new transfer roller or charge roller with your bare hands; oils from skin onthe transfer roller can cause print quality defects.Transfer Roller Replacement:1. Turn the printer around so the front is facing you; open the front doorsand remove the print cartridge.2. Unsnap the Transfer Roller Assembly from the left pivot arm.3. Lift the Transfer Roller Assembly toward the left and remove it from the printer.4. Leave the protective wrapper on the transfer roller and insert into thebearing on the right. Then snap the left end of the roller into position.5. Remove the protective wrapper from the roller and discard.Charge Roller Replacement:1. Locate the charge roller toward the rear of the opening, grasp it with your left hand and push the right mounting bracketaway until the charge roller drops out.

/ 2

Related manuals for Dell M5200