Dell Networking C9010 Installation Manual

Also see for Networking C9010: Getting started guide

Contents

The base C9010 configuration package consists of:• One C9010 chassis• One full-width C9000 Series RPM– C9000-RPM-2.56T displays in SW output.– 07KPC3 or 0N90RW is on the HW label.• Three C9000 Series fan modules– C9000-FAN displays in SW output.– 0C94MF is on the HW label.• One AC PSU (110-230V switching)– C9000-PWR-AC displays in SW output.– D3000E-S0 is on the HW label.• AC power cord (IEC 60320 C19 cable)• One DB-9 to RJ-45 serial console cable• One rack bar with four screws and washers• Eight cage nuts (four for the rack bar; four for the chassis thumb screws)• Blank panels: one RPM, three PSU, and nine half-width line card blanks• Two cable management brackets• C9010 Getting Started Guide• Safety and Regulatory Information• Warranty and Support Information• Software License AgreementIn addition, you can order the following items:• Up to three additional PSUs for redundancy or additional power• Half-width line cards:– 6-Port 40 Gigabit Ethernet QSFP+ (C9000LC0640 displays in SW output.)– 24-Port 1/10 Gigabit Ethernet SFP+ (C9000LC2410G displays in SW output.)– 24-Port 1/10 Gigabit Ethernet Base-T RJ-45 (C9000LC2410T displays in SW output.)• SFP+ optics• QSFP+ optics• SFP+ direct attach copper (DAC) cables• QSFP+ DAC cables• DB-9 adapter• Dell ReadyRails™ kit (#1 and #2 Phillips and flat-tipped screwdrivers required) with four cage nuts• Rack mount tray• C1048P port extenders for use with the C9010Before You Start: Site PreparationBefore installing the C9010 switch, make sure that your installation site meets these requirements:• Clearance: Ensure there is adequate space in front of the switch so you can read the light-emittingdiodes (LEDs) and adequate space around and behind the chassis for cabling, power connections,6 C9010 Hardware Description