OptiPlex 980 Technical Guidebook Page 24Communications - Integrated LANNOTE: MT supports full height card, DT supports low profile card or full height card with optional riser. SFF supports lowprofile card.Integrated Intel® 82578 Gigabit Ethernet LAN 10/100/1000 MT DT SFFExternal Connector Type RJ45Data Rates supported 10/100/1000 MbpsController DetailsController bus architecture (example PCIe 1.0a x1) Intel Gigabit LAN Connect Interface(GLCI) and LAN Connect Interface (LCI)Integrated memory N/AData transfer mode (example Bus-Master DMA) N/APower consumption (full operation per data rate connection speed) 781mW (Max.)Power consumption (standby operation) with WOL enabled 200mW (Max, 100Mb)66mW (Max, 10Mb)Power consumption (standby operation) with WOL disabled in BIOS 0mW (Max)Power consumption (standby operation) with WOL disabled with driver 47mW (Max)IEEE standards compliance (example 802.1P) 802.3Hardware Certifications (example FCC, B, GS mark…) N/ABoot ROM Support EEPROM (located in SPI)Network Transfer Mode (example Full Duplex, Half Duplex)Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps10BASE-T (full-duplex) 20 Mbps100BASE-TX (half-duplex) 100 Mbps100BASE-TX (full-duplex) 200 Mbps1000BASE-T (full-duplex) 2000 Mbps10 Mb (full/half-duplex)100 Mb (full/half-duplex)1000 Mb (full-duplex)EnvironmentalOperating temperature 0° C to 85° C (32° F to 185° F)Operating humidity 20% to 80% (non-condensing)Operating System Driver Support Windows XP 32-Bit, Windows Vista32-bit, Windows Vista 64-bit, Win7 32-bit,Win7 64Bit.Manageability (examples WOL, PXE..) WOL, PXE 2.1Management Capabilities Alerting (examples ASF 2.0 AMT…) iAMT6.01 This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernetserver and network infrastructure is required.