Dell Olympus O-T600 Installation And Service Manual

Removing the TPMSteps1. Locate the TPM connector on the system board.2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.3. Slide the TPM module out from its connector.4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.5. Pull the plastic rivet out of its slot on the system board.Installing the TPMSteps1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.3. Press the plastic rivet until the rivet snaps into place.Figure 116. Installing the TPMNext steps1. Install the system board.2. Follow the procedure listed in After working inside your system on page 28.Initializing TPM for BitLocker usersStepsInitialize the TPM.For more information, see .The TPM Status changes to Enabled, Activated.Initializing the TPM 1.2 for TXT usersSteps1. While booting your system, press F2 to enter System Setup.2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.3. From the TPM Security option, select On with Pre-boot Measurements.4. From the TPM Command option, select Activate.5. Save the settings.Installing and removing system components 121