Dell Olympus O-T600 Installation And Service Manual

3. Remove the expansion card holder.Steps1. Unpack the expansion card and prepare it for installation.For instructions, see the documentation accompanying the card.2. Open the expansion card latch adjacent to the slot you want to install the expansion card.3. Remove the existing expansion card or filler bracket from the expansion card holder.NOTE: Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain FCCcertification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflowinside the system.4. Holding the card by its edges, position the card so that the card aligns with the expansion card connector.5. Insert the card firmly into the expansion card connector until the card is fully seated.6. Close the expansion card latch by pushing the latch up until the latch snaps into place.7. Connect the data cables to the expansion card and/or the power cables to the GPU card.Figure 78. Removing the filler bracketFigure 79. Installing an expansion cardNext steps1. Install the expansion card holder.2. Follow the procedure listed in After working inside your system on page 28.94 Installing and removing system components