Power management screen optionsOption DescriptionAC Recovery Specifies how the computer will respond when AC power is applied after an AC power loss. You can set the ACRecovery to:• Power Off (default)• Power On• Last Power StateAuto On Time Allows you to set the time at which the computer must turn on automatically. The options are:• Disabled• Every Day• Weekdays• Select DaysDefault setting: DisabledNOTE: This feature does not work if you turn off your computer using the switch on a power stripor surge protector or if Auto Power is set to disabled.Deep SleepControlAllows you to define the controls when Deep Sleep is enabled.• Disabled• Enabled in S5 only• Enabled in S4 and S5 – This option is enabled by default.Fan ControlOverrideControls the speed of the system fan. This option is disabled by default.NOTE: When enabled, the fan runs at full speed.USB WakeSupportAllows you to enable USB devices to wake the system from Standby.NOTE: This feature is only functional when the AC power adapter is connected. If the AC poweradapter is removed during Standby, the system setup removes power from all the USB ports toconserve battery power.• Enable USB Wake SupportDefault setting: The option is disabled.Wake on LAN/WLANAllows you to enable or disable the feature that powers on the computer from the Off state when triggered by aLAN signal.• Disabled• LAN Only• WLAN Only• LAN or WLANDefault setting: DisabledBlock Sleep This option lets you block entering to sleep (S3 state) in operating system environment.Block Sleep (S3 state)Default setting: This option is disabledIntel Ready Mode This option enables the capability of Intel Ready Mode technology.POST behavior screen optionsOption DescriptionNumlock LED Specifies if the NumLock function can be enabled when the system boots. This option is enabled by default.Keyboard Errors Specifies whether keyboard related errors are reported when it boots. This option is enabled by default.70 System setup