4. If you are installing a card in an empty card connector on the system board, remove the filler bracket to create a card-slot opening at the back of thecomputer. Then continue with step 6.5. If you are installing a card to replace one already installed in the computer, remove the installed card (see Removing a PCI Card).6. Prepare the card for installation.7. If you are installing a PCI Express x16 card, hold the securing-tab release lever away from the card connector as you insert the new card into theconnector slot.8. Place the card in the connector and press down firmly. Using the following illustration as a guide, ensure that the card is fully seated in the slot.9. Gently rotate the release tab downward to move the card-retention latch into place to secure the cards.10. Connect any cables that should be attached to the card.NOTE: See the documentation that came with the card for information on configuring the card, making internal connections, or customizing it foryour computer.1 release tab on card-retention latch 2 card3 card-edge connector 4 card connectorWARNING: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, besure to unplug your computer from its electrical outlet before installing any cards.1 card fully seated 2 card not fully seated3 bracket within slot 4 bracket caught outside of slotNOTE: If you are installing a PCI Express x16 card, ensure that the securing tab on the connector's release lever fits into the notch on the frontend of the card.CAUTION: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properlyor cause damage to the equipment.
