Dell OptiPlex GX520 User Manual

Contents

Dell OptiPlex GX520 User Manual Manual pdf 70 page image

2. Gently push the release tab on the card retention latch from the inside to pivot the latch open. Because the latch is captive, it will remain in the openposition.3. Open the card retention mechanism that secures the card in place from the top:a. Place your thumb on the top of the card retention mechanism and grip the bottom of the retention mechanism with your fingers.b. With your free hand, gently squeeze the sides of the card retention mechanism to release it from the tab slots holding it in place.c. Pivot the card retention mechanism upward to release it from the two tab slots.4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.If you need a filler bracket, contact Dell.5. Before you replace and lower the card retention mechanism, ensure that:l The tops of all cards and filler brackets are flush with the alignment bar.l The notch in the top of the card or filler bracket fits around the alignment guide.6. Gently press down on the card retention mechanism to secure the adapter bracket in place.7. Secure the card(s) by closing the card retention latch and snapping it into place.8. Replace the computer cover.Serial Port AdaptersInstalling a Serial Port Adapter1. Follow the procedures in "Before You Begin."1 card retention latch 4 card-edge connector2 alignment guide 5 card connector3 card 6 release tabNOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dustand dirt out of your computer.NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of yourcomputer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.NOTE: The serial port adapter for your mini tower computer also includes two PS/2 connectors.