Dell Optiplex 9010 All In One Owner's Manual

Also see for Optiplex 9010 All In One: Setup and features information Reference guide

Contents

Installing the Display Panel1. Tighten the screws that secure the display brackets to the display panel.2. Align the display assembly over the middle frame.3. Connect all the touchscreen-board cables to the connectors on the display panel.4. Affix the tape that adheres the connectors to the display panel.5. Align the chassis over the display panel and tighten the screws to secure the chassis to the middle frame.6. Replace the screws that secure the chassis to the middle frame.7. Connect the LVDS cable to its connector and connect any other cables or antennae around the edges of the basepanel.8. Install:a) system boardb) antenna modulec) speakersd) processor fane) heat-sink assemblyf) power supply unitg) power-supply fanh) converter boardi) power-button boardj) intrusion switchk) hard drivel) optical drivem) WLAN cardn) input/output board shieldo) system-board shieldp) VESA mount bracketq) back coverr) VESA stand9. Follow the procedures inAfter Working Inside Your Computer.Removing the Antenna Modules1. Follow the procedures inBefore Working Inside Your Computer.2. Remove the:a) VESA standb) back coverc) VESA mount bracketd) system-board shielde) input/output board shieldf) WLAN cardg) optical driveh) hard drivei) intrusion switchj) power button boardk) converter boardl) processor fan39