Figure 24. Removing and Installing the Optical Drive1. optical drive2. power/data cable3. release tabInstalling The Optical DriveNOTE: This procedure applies only to PowerEdge R720.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. If installed, remove the front bezel.2. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.3. Open the system.4. To remove the optical drive blank, press the blue release tab at the back of the blank and push the blank out of thesystem.5. Align the optical drive with the optical drive slot on the front of chassis.6. Slide the optical drive into the slot until the latch snaps into place.7. Connect the power/data cable to the back of the drive.8. Route the power/data cable along the inside left wall of the chassis.9. Connect the power/data cable to the connectors on the system board.10. Install the cooling-fan assembly.11. Close the system.12. If applicable, install the front bezel.13. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.55
