Figure 39. Removing and Installing the SD vFlash Card1. SD vFlash card2. SD vFlash card slot3. To install the SD vFlash card, with the label side facing up, insert the contact-pin end of the SD card into the cardslot on the module.NOTE: The slot is keyed to ensure correct insertion of the card.4. Press inward on the card to lock it into the slot.Removing The vFlash Media UnitNOTE: This procedure applies only to PowerEdge R720xd.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Remove the screw securing the vFlash media unit to the chassis.4. Remove the cable from the vFlash media unit and the backplane.5. Slide the vFlash media unit toward front of chassis and lift it out of the system.6. Close the system.7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.72
