Installing System Components 12713 Enter the System Setup program and if the time and date are stillincorrect, see "Getting Help" on page 175 for instructions on obtainingtechnical assistance.Sideplane BoardRemoving the Sideplane BoardCAUTION: Only trained service technicians are authorized to remove the systemcover and access any of the components inside the system. See your ProductInformation Guide for complete information about safety precautions, workinginside the computer, and protecting against electrostatic discharge.1 Turn off the system and attached peripherals, and disconnect the systemfrom the electrical outlet.2 Open the system. See "Opening the System" on page 71.3 Remove the SAS controller daughter card. See "Removing a SASController Daughter Card" on page 86.4 Remove any cables from the sideplane board.NOTICE: When detaching the control panel cable from the sideplane board,squeeze the metal ends of the cable connectors and gently work the connector outof the socket. Do not pull on the cable to unseat the connector. Doing so candamage the cable.5 Pressing inward on the sideplane release tabs, lift the sideplane up andaway from the system. See Figure 3-29Installing the Sideplane Board1 Insert the sideplane board into sideplane slots along the left wall of thechassis and lower the sideplane board so that the pin collars connect withthe two pins on the system board. Press the sideplane down until sideplaneconnector is fully seated into the system board connector. See Figure 3-29.2 Reattach the control panel cable to the sideplane board.3 Replace the storage controller daughter card. See "Installing a SASController Daughter Card" on page 84.4 Close the system. See "Closing the System" on page 71.
