Console#reloadSystem will be restarted, continue ? yConsole#PortsThe Port Manager contains links to the following options:l Port Configurationl Trunk Configurationl Broadcast Controll Port MirroringPort ConfigurationOn the Port Configuration page, you can view and edit port parameters. For each port number listed in the Port column, you can change the followingparameters listed by column name on the screen:l Name/Type — Allows a user-defined label for the port and indicates the type of port:¡ 100Base-TX — 10/100Base-TX RJ-45 port¡ 1000Base-TX — 10/100/1000Base-T RJ-45 port¡ 1000Base-SFP — gigabit SFP transceiver portl Admin/Oper — Allows the network administrator to manually disable a port and indicates the status of the link: up or down.l Speed/Duplex Mode — Allows the manual selection of port speed and duplex mode and indicates the current port speed and mode.l Flow Control — Allows automatic or manual selection of support for flow control and indicates the type of flow control currently in use.l Autonegotiation/Port Capabilities — Allows autonegotiation to be enabled/disabled and indicates the capabilities of the port that are advertised duringautonegotiation:¡ 10h — Supports 10-megabits per second (Mbps) half duplex.¡ 10f — Supports 10-Mbps full duplex.¡ 100h — Supports 100-Mbps half duplex.¡ 100f — Supports 100-Mbps full duplex.¡ 1000h — Supports 1000-Mbps half duplex.¡ 1000f — Supports 1000-Mbps full duplex.¡ Sym — Supports symmetric operation of full-duplex flow control. The port can transmit and receive pause frames for flow control (gigabit portsonly).¡ FC — Supports full-duplex flow control.l Trunk — Indicates whether a port is a member of an aggregated link or trunk.CLI CommandsThe following table summarizes the equivalent CLI commands for items in the Ports/Port Configuration page.NOTICE: If autonegotiation is disabled for an RJ-45 port, the auto- MDI/MDI-X pin signal configuration is also disabled.Command Usage