Configuring Switch Information 3193 Click Apply Changes.Bridge Multicast is enabled on the device.Enabling IGMP Snooping on the Device1 Open the Multicast Global Parameters page.2 Select Enable in the IGMP Snooping Status field.3 Click Apply Changes.IGMP Snooping is enabled on the device.Enabling Multicast Forwarding and IGMP Snooping Using CLI CommandsThe following table summarizes the equivalent CLI commands for enabling Multicast forwardingand IGMP Snooping as displayed on the Multicast Support page.The following is an example of the CLI commands:Console (config)# bridge multicast filteringConsole (config)# ip igmp snoopingAdding Bridge Multicast Address MembersThe Bridge Multicast Group page displays the ports and LAGs attached to the Multicast servicegroup in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which theport or LAGs joined the Multicast group. Ports can be added either to existing groups or to newMulticast service groups. The Bridge Multicast Group page permits new multicast service groupsto be created. The Bridge Multicast Group page also assigns ports to a specific multicast serviceaddress group.To open the Bridge Multicast Group page, click Switch→Multicast Support→Bridge MulticastAddress in the tree view.Table 7-31. Multicast Forwarding and Snooping CLI CommandsCLI Command Descriptionbridge multicastfilteringEnables filtering of Multicast addresses.ip igmp snooping Enables Internet Group MembershipProtocol (IGMP) snooping.
