Dell PowerConnect 6200 Series Getting Started Manual

Also see for POWERCONNECT 6200 SERIES: Getting started guide Configuration guide

38 Guide de mise en routew w w . d e l l . c o m | s u p p o r t . d e l l . c o m L'exemple suivant montre la séquence d'invites et de réponses d'une session exemple de l'assistantEasy Setup de Dell. Les valeurs utilisées sont celles qui sont indiquées ci-dessus.Au démarrage du commutateur (après le POST), la boîte de dialogue suivante s'affiche :Welcome to Dell Easy Setup WizardThe setup wizard guides you through the initial switchconfiguration, and gets you up and running as quickly as possible.You can skip the setup wizard, and enter CLI mode to manuallyconfigure the switch. You must respond to the next question to runthe setup wizard within 60 seconds, otherwise the system willcontinue with normal operation using the default systemconfiguration. Note: You can exit the setup wizard at any pointby entering [ctrl+z].Would you like to run the setup wizard (you must answer thisquestion within 60 seconds)? [Y/N] yÉtape 1:The system is not configured for SNMP management by default. Tomanage the switch using SNMP (required for Dell Open Manage NetworkManager) you can:o Set up the initial SNMP version 1 & 2 now.o Return later and set up other SNMP accounts. (For moreinformation on setting up an SNMP version 3 account, see the userdocumentation).Would you like to configure the SNMP management interface now?[Y/N] yTo configure the SNMP management account you must specifythe management system IP address and the "community string" orpassword that the particular management system uses to access theswitch. The wizard automatically assigns the highest access level[Privilege Level 15] to this account. You can use Dell Open ManageNetwork Manager or other management interfaces to change thissetting and to add additional management systems later. For moreinformation on adding management systems, see the User’s Guide.