Dell PowerConnect J-8208 Release Note

Also see for PowerConnect J-8208: Hardware guide Quick start guide Release note

Contents

Dell PowerConnect J-8208 Release Note Manual pdf 5 page image

disable distributed PPM and run PPM just on the Routing Engine only if there is acompelling reason to disable distributed PPM.• Enhancements to LCD menus—Using CLI commands, administrators can disable theStatus menu, the Maintenance menu, and the options in these menus to prevent usersfrom viewing certain details about the switch and from configuring and troubleshootingthe switch from the LCD menu.• IPv6 path maximum transmission unit discovery—The IPv6 path maximumtransmission unit (MTU) discovery feature is now available on J-EX8200 switches.Layer 2 and Layer 3 Protocols• IPv6 virtual routing and forwarding (VRF) multicast—IPv6 multicast traffic is nowsupported for VRF on J-EX4200, and J-EX8200 switches.Management and RMON• 802.1ag OAM support on J-EX4200 switches—802.1ag is an IEEE standard forconnectivity fault management (CFM). The following features are supported: continuitycheck protocol, linktrace protocol, and loopback protocols.• sFlow enhancements on J-EX Series switches—You can configure the IP address tobe assigned to the sFlow agent and the IP address to be used in sFlow datagrams. Byconfiguring the IP addresses, you can ensure that the IP addresses are not dynamicand do not change when the switch restarts.Packet Filters• Enhancements to firewall filter actions supported on J-EX8200 switches—The log,reject, and syslog actions are now supported for ingress firewall filters on J-EX8200switches. The reject action is supported on Layer 3 interfaces (router firewall filters)only.Related Topics Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switcheson page 5•• Limitations in JUNOS Release 10.2 for J-EX Series Switches on page 6• Outstanding Issues in JUNOS Release 10.2 for J-EX Series Switches on page 9Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series SwitchesThe following changes in system behavior, configuration statement usage, or operationalmode command usage have occurred since the previous release and might not yet bedocumented in the JUNOS Software for J-EX Series switches documentation.Access Control and Port Security• The following enhancements have been made to the show lldp commands:• The show lldp local-information command now includes information about the localmanagement address and type.5Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches