Dell PowerConnect M6220 Series Getting Started Manual

Also see for PowerConnect M6220: Release notes Configuration guide Cli reference guide Configuration guide Release note

はじめに 113手順 3:Next, an IP address is setup. The IP address is defined on thedefault VLAN (VLAN #1), of which all ports are members. This is theIP address you use to access the CLI, Web interface, or SNMPinterface for the switch.Optionally you may request that the system automatically retrievean IP address from the network via DHCP (this requires that youhave a DHCP server running on the network).To setup an IP address:Please enter the IP address of the device (A.B.C.D) or enter "DHCP"(without the quotes) to automatically request an IP address fromthe network DHCP server.192.168.2.1Please enter the IP subnet mask (A.B.C.D or /nn):255.255.255.0手順 4:Finally, set up the gateway. Please enter the IP address of thegateway from which this network is reachable192.168.1.1This is the configuration information that has been collected:SNMP Interface = "public"@192.168.2.1User Account setup = adminPassword = **********Management IP address = 192.168.2.1 255.255.255.0Gateway = 0.0.0.0手順 5:If the information is correct, please select (Y) to save theconfiguration, and copy to the start-up configuration file. If theinformation is incorrect, select (N) to discard configuration andrestart the wizard: [Y/N]yThank you for using the Dell Easy Setup Wizard. You will now enterCLI mode......console>