62 Guide de mise en routew w w . d e l l . c o m | s u p p o r t . d e l l . c o m Au démarrage du commutateur (après l'auto-test de démarrage), la boîte de dialogue suivantes'affiche :Welcome to Dell Easy Setup WizardThe Setup Wizard guides you through the initial switchconfiguration, and gets you up and running as quickly as possible.You can skip the setup wizard, and enter CLI mode to manuallyconfigure the switch. You must respond to the next question to runthe setup wizard within 60 seconds, otherwise the system willcontinue with normal operation using the default systemconfiguration.Note: You can exit the setup wizard at any pointby entering [ctrl+z].Would you like to run the setup wizard (you must answer thisquestion within 60 seconds)? [Y/N] yÉtape 1 :The system is not setup for SNMP management by default. To managethe switch using SNMP (required for Dell Network Manager) you can:o Set up the initial SNMP version 2 account now.o Return later and setup other SNMP accounts. (For more informationon setting up an SNMP version 1 or 3 account, see the userdocumentation).Would you like to setup the SNMP management interface now? [Y/N] yTo setup the SNMP management account you must specify themanagement system IP address and the "community string" orpassword that the particular management system uses to access theswitch. The wizard automatically assigns the highest access level[Privilege Level 15] to this account. You can use Dell NetworkManager or other management interfaces to change this setting, andto add additional management system later. For more information onadding management systems, see the user documentation.To add a management station:Please enter the SNMP community string to be used.{public}:publicPlease enter the IP address of the Management System (A.B.C.D)or wildcard (0.0.0.0) to manage from any Management Station.{0.0.0.0}:192.168.2.1