Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide Instant User Interface | 23SettingsThis link displays the Settings window. The Settings consists of the following tabs:Figure 9 Settings Link General— View or edit the Name, IP address, NTP Server, and DHCP server settings of the VirtualController. For information about Virtual Controller settings and NTP Server, see Chapter 9, “VirtualController” and Chapter 8, “NTP Server” . For information about Auto join mode, Terminal Access, LEDdisplay, TFTP Dump Server, and Deny inter user bridging see Chapter 5, “Managing IAPs” . Admin— View or edit the admin credentials for access to the Virtual Controller Management User Interface.See “Management Authentication Settings” on page 116 for more information. You can also configure DellPowerConnect W-AirWave in this tab. See “Configuring Dell PowerConnect W-AirWave” on page 191 formore information. Wired— Specify the desired profile for each port of the IAP. See Chapter 21, “Ethernet Downlink” for moreinformation. RTLS— View or edit the RTLS server settings. Dell RTLS— Enable this to integrate with Dell PowerConnect W-AirWave Management platform,Ekahau Real Time Location Server and Nearbuy Real Time Location Server. Specify the IP address andport number of the server to which location reports are sent, a shared secret key, and the frequency atwhich packets are sent to the server. Update indicates how frequently the Virtual Controller updates theRTLS server. Aeroscout— Enables the AP to send RFID tag information to an AeroScout real-time asset location(RTLS) server. Specify the IP address and port number of the AeroScout server to which location reportsshould be sent.NOTE: Use the Show/Hide Advanced option on the bottom-left of the Settings window to view or hide the advanced options.
