Dell PowerEdge 350 User Manual

Also see for PowerEdge 350: Installation guide Manual Installation guide System Diagnostics Information Update Information update

Contents

Dell PowerEdge 350 User Manual Manual pdf 27 page image

support.dell.comUsing the System Setup Program 3-7— Secondary IDE Master — Displays the name of your system’s installeddevice, or displays Not Installed. If an IDE device is detected, you can con-figure the following options: Type (Auto is the default), LBA Mode Control(Enabled is the default), Multi-Sector Transfers (16 sectors is the default),PIO Mode (Auto is the default), Ultra MDA (Disabled is the default).— Secondary IDE Slave — Displays the name of your system’s installeddevice, or displays Not Installed. If an IDE device is detected, you can con-figure the following options: Type (Auto is the default), LBA Mode Control(Enabled is the default), Multi-Sector Transfers (16 sectors is the default),PIO Mode (Auto is the default), Ultra MDA (Disabled is the default).ï Diskette Configuration — Configures the following diskette drive settings:— Diskette Controller — Enables (the default) or disables the integrated dis-kette controller.— Floppy A — Enables (the default) or disables the diskette drive and specifiesits size: 360 KB 5.25”, 1.2 MB 5.25”, 720 KB 3.5”, 1.44/1.25 MB 3.5”, (thedefault), or 2.88 MB 3.5”.— Diskette Write Protect — Enables or disables (the default) write-protect forthe diskette drive.ï Event Log Configuration — Configures the following event log options:— Event Log — Displays whether or not space is available in your system’sevent log. This option has no user configurable settings.— Event Log Validity — Displays whether or not the contents of your sys-tem’s event log are valid. This option has no user configurable settings.— Clear All Event Logs — Clears your system’s event log after rebooting. Nois the default option.— Event Logging — Enables (the default) or disables event logging.— ECC Event Logging — Enables (the default) or disables ECC event logging.Security MenuSelecting the Security option on the menu bar allows you to set the following pass-word and security features:ï User Password Is — Displays whether or not your system has a user passwordinstalled (entered). This option has no user configurable settings.ï Supervisor Password Is — Displays whether or not your system has a supervi-sor password installed (entered). This option has no user configurable settings.ï Set Supervisor Password — Specifies a supervisor password that can be up toseven alphanumeric characters long. The default option is no supervisor pass-word installed.ï Set User Password — Specifies a user password that can be up to seven alphanumeric characters long. The default option is no supervisor password installed.