Dell PowerEdge 350 User Manual

Also see for PowerEdge 350: Installation guide Manual Installation guide System Diagnostics Information Update Information update

Contents

Dell PowerEdge 350 User Manual Manual pdf 29 page image

support.dell.comUsing the System Setup Program 3-9System Management MenuSelecting the System Management menu option allows you to set the followingserver management features:ï Serial Console Redirection — Enables or disables (the default) your system’sserial console redirection.ï Baud Rate — Sets your system’s baud rate: 9600, 19.2 KB (the default), 38.4 KB,or 115 KB.ï Flow Control — Enables or disables one of the following flow controls: No FlowControl, CTS/RTS (the default), XON/XOFF, or CTS/RTS+CD.Exit MenuSelecting the Exit menu option allows you to exit the System Setup program whilesaving, discarding, or loading default settings:ï Exit Saving Changes — Exits your system’s setup and saves changes. Thisoption has no user-configurable settings.ï Exit Discarding Changes — Exits your system’s setup and discard changes. Thisoption has no user-configurable settings.ï Load Setup Defaults — Loads your system’s setup default settings. This optionhas no user-configurable settings.ï Load Custom Defaults — Loads your system’s custom settings. This option hasno user-configurable settings.ï Save Custom Defaults — Saves your system’s custom settings. This option hasno user-configurable settings.ï Discard Changes — Discards your system’s changes. This option has no user-configurable settings.Using the System Password FeaturesNOTICE: The password features provide a basic level of security for thedata on your system. However, they are not foolproof. If your data requiresmore security, it is your responsibility to obtain and use additional forms ofprotection, such as data encryption programs.The System Setup program allows you to install supervisor and user passwords. Asupervisor password is used to access the System Setup program while a user pass-word is used to access the system, such as when logging in.Your Dell system is shipped to you without the supervisor password feature installed.If system security is a concern, you should operate your system only with supervisorpassword protection.You can assign a supervisor password whenever you use the System Setup program.After a supervisor password is assigned, only those who know the password have fulluse of the System Setup program.