|
3-16 Dell PowerEdge 4300 Systems User’s Guidef. At the Exit Confirmation dialog box, remove theDell Server Assistant CD,insert theDell IntranetWare Support CD, select OK, and press toreboot the server.2. From the Dell IntranetWare Support Menu, type 1 to select Create a primaryDOS partition.3. From the Hard-Drive Preparation Menu, type 2 to select Run FDISK in auto-mated mode.NOTE: Dell recommends running the fdiskutility in automated mode unless youneed to specify a different size for the primary MS-DOS partition. Running thefdiskutility in automated mode creates a 25-MB partition.4. At the Warning screen, read the information and type y to continue.The program partitions and then reboots the system.5. From the Dell IntranetWare Support Menu, type 2 to select Format primaryDOS partition.6. When prompted, type y and press to proceed with the format.7. From the Dell IntranetWare Support Menu, type 3 to select Copy DOS systemfiles to hard-drive.8. Read the message that appears and type y to continue.The message FILE TRANSFER COMPLETE appears and you are returned to thea:\ prompt.9. Remove theDell IntranetWare Support CD from the drive and press to reboot the system.Your hard-disk drive has been prepared for IntranetWare installation. Continue tothe next subsection, “Installing SCSI Drivers During IntranetWare 4.11Installation.”,QVWDOOLQJ6&6,'ULYHUV'XULQJ,QWUDQHW:DUH,QVWDOODWLRQThis section describes how to install the aic78u2.ham and aha2940.ham drivers atthe same time you install IntranetWare. If you have a RAID controller, you should alsoinstall the pedge4xx.ham driver during this process.If IntranetWare is already installed and you want to install or update the aic78u2.hamand aha2940.ham drivers, refer to the IntranetWareUser’s Guide for installationinstructions. Also, refer to the IntranetWareUser’s Guide for information about parti-tioning, creating a server name, and checking the Internetwork Packet Exchange (IPX)network number.33255bk0.book Page 16 Tuesday, August 25, 1998 8:46 AM
|
