|
Installing and Configuring SCSI Drivers 3-21To install the IntranetWare Support Pack 5, follow these steps:1. Start IntranetWare.2. Load the Support Pack file onto a workstation that is attached to the PowerEdgeserver.3. Copy the Support Pack file to a volume on the server.4. Expand the file by typing iwsp5b.exe, and press .5. Follow the directions in the iwsp5b.txt file included with the Support Pack.When Support Pack 5 has been applied, you can install SMP on your system.,QVWDOOLQJ6036XSSRUWNOTE: Before symmetric multiprocessing (SMP) can be installed on your system, youmust apply the IntranetWare Support Pack 4 or later to the IntranetWare operatingsystem. See “Installing the Dell-Supplied Novell Patches and Support Pack 5” foundearlier in this chapter.To add SMP support to your IntranetWare installation, follow these steps:1. Start IntranetWare.2. At the IntranetWare console prompt, type Load install and press .3. At the installation screen that appears, select Multi CPU Options and press.4. At the SMP Installation Options screen, select Select a Platform Support-Module and press .5. At the Select a Driver screen, select MPS14.PSM and press .A confirmation screen asks if you want to load the selected module.6. Select Yes and press .A message screen appears.7. Press to continue and then to exit to the console prompt.8. Type down to down the server and then exit to exit to MS–DOS.9. Reboot the system to enable SMP support.8VLQJVWDUWXSQFIDQGDXWRH[HFQFIThe startup.ncf and autoexec.ncf files contain a set of commands that are executedduring the boot routine. The startup.ncf file contains commands to load the disk driv-ers. Once startup.ncf loads disk drivers, control is passed to the autoexec.ncf file tocomplete the boot routine. For additional information on the startup.ncf andautoexec.ncf files, refer to your IntranetWare documentation.33255bk0.book Page 21 Tuesday, August 25, 1998 8:46 AM
|
