c. Install a new SD card in slot 2.5. If the Internal SD Card Redundancy option in the Integrated Devices screen of the System Setup isset to Mirror mode and SD card 2 has failed, insert the new SD card into SD card slot 2.6. If the Internal SD Card Redundancy option in Integrated Devices screen of the System Setup is setto Disabled, replace the failed SD card with a new SD card.7. Install the sled in the enclosure.8. Enter the System Setup and ensure that the Internal SD Card Port option is enabled and Internal SDCard Redundancy option is set to Mirror mode.9. Check if the SD card is functioning properly.If the problem persists, see Getting Help.Troubleshooting processors1. Turn off the sled using the operating system commands or the CMC.2. Remove the sled from the enclosure.3. Ensure that the processor(s) and heat sink(s) are properly installed.4. If your system only has one processor installed, ensure that it is installed in the primary processorsocket (CPU1).5. Install the sled in the enclosure.6. Turn on the sled.7. Run the appropriate diagnostic test. For more information, see Using System Diagnostics.If the problem persists, see Getting Help.Troubleshooting the system boardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.Steps1. Turn off the sled using the operating system commands or the CMC.2. Remove the sled from the enclosure.3. Clear the sled NVRAM.4. If the problem persists with the sled, remove and reinstall the sled in the enclosure.5. Turn on the sled.6. Run the appropriate diagnostic test. For more information, see Using system diagnostics.If the tests fail, see Getting Help.119
