Figure 11. Removing and Installing a Mezzanine Card1. mezzanine cards (2)2. Fabric B mezzanine card slot3. Fabric C mezzanine card slot4. retention latchInstalling A Mezzanine CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Remove the blade from the enclosure.2. Open the blade.3. Open the retention latch by pressing the ridged area on the latch with your thumb and lifting the end of the latch.4. If present, remove the connector cover from the mezzanine card bay.NOTE: Hold the mezzanine card by its edges only.5. Mezzanine cards are designed to fit in either card slot. Rotate the card to align the connector on the bottom of themezzanine card with the corresponding socket on the system board.6. Lower the card into place until it is fully seated and the plastic clip on the outer edge of the card fits over the side ofthe blade chassis.7. Close the retention latch to secure the mezzanine card.8. Close the blade.37
