Dell PowerEdge R620 Owner's Manual

Contents

Dell PowerEdge R620 Owner's Manual Manual pdf 28 page image

Menu Item DescriptionRemote TerminalTypeAllows you to set the remote console terminal type. By default, the Remote Terminal Typeoption is set to VT 100/VT 220.Redirection AfterBootAllows you to enable or disable to the BIOS console redirection when the operating system isloaded. By default, the Redirection After Boot option is set to Enabled.System Profile Settings ScreenMenu Item DescriptionSystem Profile Allows you to set the system profile. If you set the System Profile option to a mode other thanCustom, the BIOS automatically sets the rest of the options. You can only change the rest of theoptions if the mode is set to Custom. By default, the System Profile option is set to PerformancePer Watt Optimized (DAPC). DAPC is Dell Active Power Controller.NOTE: The following parameters are available only when the System Profile is set toCustom.CPU PowerManagementAllows you to set the CPU power management. By default, the CPU Power Management optionis set to System DBPM (DAPC). DBPM is Demand-Based Power Management.Memory Frequency Allows you to set the memory frequency. By default, the Memory Frequency option is set toMaximum Performance.Turbo Boost Allows you to enable or disable the processor to operate in turbo boost mode. By default, theTurbo Boost option is set to Enabled.C1E Allows you to enable or disable the processor to switch to a minimum performance state whenit is idle. By default, the C1E option is set to Enabled.C States Allows you to enable or disable the processor to operate in all available power states. Bydefault, the C States option is set to Enabled.Memory PatrolScrubAllows you to set the memory patrol scrub frequency. By default, the Memory Patrol Scruboption is set to Standard.Memory RefreshRateAllows you to set the memory refresh rate. By default, the Memory Refresh Rate option is set to1x.Memory OperatingVoltageAllows you to set the DIMM voltage selection. When set to Auto, the system automatically setsthe system voltage to the optimal setting based on the DIMM capacity and the numbers ofDIMMs installed. By default, the Memory Operating Voltage option is set to Auto.System Security ScreenMenu Item DescriptionIntel AES-NI The Intel AES-NI option improves the speed of applications by performing encryption anddecryption using the Advanced Encryption Standard Instruction Set and is set to Enabled bydefault.System Password Allows you to set the system password. This option is set to Enabled by default and is read-only ifthe password jumper is not installed in the system.28